The perfect off-white with just enough warmth but still remaining crisp, fresh and bright.
Ensure surfaces to be painted are clean and free from peeling paint, mould, dirt, dust and grease. Sanding or priming is generally unnecessary, as the paint will stick to most surfaces. Painting on plastic, glass and metal may require use of an appropriate base coat. Occasionally, tannin rich timber may leach and require a sealant to be applied prior to painting. Test your piece first, and if so use a stain blocker, primer or undercoat. Our Finishing Polyseal can be applied prior to painting to block stains, applied over paint if bleed through occurs and applied on slick surfaces to help with adhesion.
Shake the tin well and stir with a broad flat stirrer. Pour out the required amount of paint into a separate container and reseal the tin airtight for longevity. Apply the paint with a good brush, foam roller or spray gun. In optimum conditions, the paint is touch dry in 30 minutes and can be re coated after 2 hours. Two coats are generally sufficient to achieve excellent coverage and opacity. This tin will cover about 7 to 8 square metres depending on the substrate.
Our Mineral Paint is formulated with a built-in topcoat and does not need sealing. To remove unwanted drips or brush strokes between coats, sand when the paint is touch dry. Avoid sanding the final coat of paint where possible, as this will disturb the built-in topcoat and will need resealing. For added durability and protection in high traffic areas, applying a sealant is recommended. Use any of our Waxes, Polyseal or Finishing Oils to both protect and achieve the desired decorative look for your piece.
CLEAN UP & DISPOSAL
Wash all brushes and tools in water.
Made in Australia.